Kramer Switcher Output

Activates a Kramer Switch Output. A dialog box appears to define the Kramer Switcher commands:

Machine select the number of the device, connected to the COM port (RS-232). Up to 8 devices can be connected.

Input select the number of the desired switcher input.

Run event – fill-in the number of frames for “earlier” or “later” command to the switcher (see the GPI section).

NOTE: This switcher control plug-in works with the old control protocol. Most of the latest Kramer switchers are Protocol 2000-compliant, so you should use the [Kramer Matrix Switcher Control] module, even if your switcher is not a matrix switcher.

IMPORTANT: The X-Pert modules do NOT support the Deck Control connector, supplied on the DeckLink breakout cable.