Clip editor

When you select the Edit Clip option for one of the playlist items, the following dialog will open:

The dialog window displays the Playlist and the Current Trimpoints of the clip to the left. Note that when the latter are different, the Current Trimpoints will be executed. To the right of the clip preview you can see general information about the video and the audio of the file.

Use the slider below the preview, as well as the buttons in order to define the desired In and Out points of the video.

NOTE: Trimming the video in the Clip Editor will not modify the actual file. Changes are applied only to the playout.

The following buttons are available here:

 - Pressing this button would reset the defined In Point to the beginning of the original clip.

 - Pressing this button will define the point, where the slider below the preview is currently located as an In Point.

 - Pressing this button will rewind the video preview from the point, where the slider is located.

 - Pressing this button will stop the playback of the preview.

 - Pressing this button will pause/resume the playback of the preview.

 - Pressing this button will initiate playout of the clip in the preview.

 - Pressing this button will forward the video preview from the point, where the slider is located.

 - Pressing this button will define the point, where the slider below the preview is currently located as an Out Point.

 - Pressing this button would reset the defined In Point to the end of the original clip.

NOTE: For frame-accurate selection, hold Ctrl while moving the slider. This also works for the buttons above and the keyboard arrows.

From the File browser below you can load a different file.

In the Title field enter a title for the current video.

You can also enter Tape ID for the video in the dedicated field, if applicable.

Enable the ☑ Incomplete check-box in case you are using an incomplete file and you do not want an Out Point to be set.

Once you are ready press OK. Press Cancel to abort changes.